Universal R-320 Manual del operador descargar pdf (Pagina 13)

SETUP AND OPERATION CONTINUED

3. After adjusting Turning Unit height, you will also need to adjust the

height and tilt of the Turning Unit Backing Plate assembly. Loosen the

ratchet handles at each guide rail mount and move the assembly up or

down to desired height. To adjust the tilt of the assembly, loosen the

two small ratchet handles and tilt the Backing Plate assembly in or out

depending on the container that is to be labeled. (See Fig.9)

ADJUSTING PRODUCT SENSOR

1. With power off, Place container at the entrance side of the Turning

Unit. The Fiber Optics of the Product Sensor needs to be in the center

of and as close to but not touching the container. There are three

Ratchet Handles to accomplish this. (See Fig.10 & 10a)

Fig.9

Ratchet

Handles

Small

Ratchet

Handles

Entrance side of

Turning Unit

Fig.10

Fiber Optics

Fig.10a

Up & Down

Adjust

Along Conveyor Adjust

Across

Conveyor

Adjust

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 68 69

Sin comentarios

Universal R-320 Manual del operador Pagina 13